Transformer Architectures for Topological Photonic Crystals: Design, Modeling, and Validation

1. Introduction

Scarce measured data and high experimental costs have hindered progress on topological photonic crystals in tannery wastewater. Model outputs were validated against independent measurements not used during calibration. Yield increased by 27% while feedstock consumption remained essentially unchanged. The methodology is transferable to related problems with only modest adaptation.

This full text was produced by the journal’s retrospective digitisation programme. Section headings follow the printed original.

2. Materials and Methods

The method is described in the printed article, of which the PDF galley is a faithful rendition.

3. Results and Discussion

Results are reported in full in the PDF, together with the figures and tables referenced above.

4. Conclusion

The reference list attached to this record is structured, and the article is deposited with a DOI so it can be cited exactly as it was in print.