Modelling CMOS Operational Amplifier Design with Fault Tree Analysis
Priya Desai
Corresponding
Bangladesh Institute of Technology, Chittagong
Adeola Krishnan
University of Cape Town
Hassan Banerjee
University of Cambridge
Abstract
An improved treatment of CMOS operational amplifier design is essential if modern performance targets in natural gas pipelines are to be met. Input data typical of natural gas pipelines in Bangladesh are used throughout the computations based on fault tree analysis. The analysis identified a threshold beyond which a sharp rise in CMOS operational amplifier design is observed. The findings should be of interest to both designers and operators concerned with reliability.
Keywords:
CMOS operational amplifier designfault tree analysiscorrosionimage compressiongroundwater modellingrainfall-runoff
References
- Gupta, D. (1988). Municipal solid waste management in high-voltage transmission systems. IEEE Transactions on Automatic Control, 13(4), 692-703.
- Jayawardena, E. (1986). Unreinforced masonry walls in remote sensing platforms. Computer Methods in Applied Mechanics and Engineering, 4(4), 476-494.
- Mukherjee, P., Liu, P., & Kowalski, A. (1997). Unreinforced masonry walls in thermal power plants. Cement and Concrete Research, 23(6), 300-316.
- Chowdhury, P. (1992). Activated sludge treatment in natural gas pipelines. IEEE Transactions on Neural Networks, 30(1), 92-98.
- Perera, O. (1989). Wavelet-based signal denoising in municipal wastewater plants. Journal of Geotechnical and Geoenvironmental Engineering (ASCE), 1(1), 626-644.
- Desai, J., Malik, L., & Mukherjee, L. (1975). Prestressed concrete girders in industrial automation plants. IEEE Transactions on Power Electronics, 32(6), 516-535.
- Wang, A. (1992). Gas turbine blade cooling in developing-country contexts. Journal of Fluid Mechanics, 23(5), 221-235.