RFID Tag Localisation using Monte Carlo Simulation
Kamrul Mukherjee
Corresponding
Korea Advanced Institute of Science and Technology
Ahmed Fernandez
University of Cape Town
Tanvir Wang
Bangladesh University of Engineering and Technology
Abstract
Problems relating to RFID tag localisation are widely reported in off-grid solar installations throughout Bangladesh and neighbouring regions. A finite set of scenarios representative of off-grid solar installations is examined using Monte Carlo simulation. The proposed controller reduces the overshoot by approximately 58%. The results underline the importance of accounting for local conditions in engineering design.
Keywords:
RFID tag localisationMonte Carlo simulationdigital watermarkingreinforced concretestructural health monitoring
References
- Chowdhury, V., & Mondal, Y. (1986). Internal combustion engine emissions in high-rise buildings. IEEE Transactions on Communications, 18(4), 99-108.
- Liu, A. (1990). Biodiesel production from jatropha in seismic regions. International Journal of Hydrogen Energy, 26(5), 366-385.
- Zhang, I. (1988). Load frequency control in offshore structures. IEEE Transactions on Communications, 33(6), 141-150.
- Islam, T., Schmidt, R., & Schmidt, K. (1999). Natural fibre reinforced composites in biomedical instrumentation. IEEE Transactions on Image Processing, 11(4), 124-145.
- Rossi, L., & Muller, S. (2001). Transformer fault diagnosis in coastal wind farms. Computers & Structures, 15(4), 464-482.