Towards Additive Manufacturing of Titanium Alloys

1. Introduction

The interplay between additive manufacturing of titanium alloys and long-term reliability in tidal river basins has received comparatively little systematic attention. Full-scale trials were conducted in tidal river basins to assess the practicality of the approach. Sensitivity analysis showed that additive manufacturing of titanium alloys accounted for most of the output variability. Future efforts should focus on scaling the approach and confirming its durability in service.

This full text was produced by the journal’s retrospective digitisation programme. Section headings follow the printed original.

2. Materials and Methods

The method is described in the printed article, of which the PDF galley is a faithful rendition.

3. Results and Discussion

Results are reported in full in the PDF, together with the figures and tables referenced above.

4. Conclusion

The reference list attached to this record is structured, and the article is deposited with a DOI so it can be cited exactly as it was in print.