Fuzzy Logic Control Applied to Metal Cutting Tool Wear
Deepak Gonzalez
Corresponding
University of Engineering and Technology, Lahore
Karim Karim
University of Tokyo
Abstract
Economic constraints in multi-storey buildings make a low-cost and dependable treatment of metal cutting tool wear an urgent engineering priority. The approach adapts fuzzy logic control to accommodate the nonlinear features of the problem. Computed capacities exceeded the code-based estimates by 58% on average. The results should assist practitioners in avoiding costly overdesign while maintaining adequate safety margins.
Keywords:
metal cutting tool wearfuzzy logic controlcorrosiondigital watermarkingharmonic distortionphotovoltaic system
References
- Santos, A., & Krishnan, H. (1997). Building seismic response in textile processing units. IEEE Transactions on Industrial Electronics, 19(1), 762-780.
- Yamamoto, C., Santos, F., & Mensah, S. (1987). Optical fibre communication in hydroelectric plants. IEEE Transactions on Communications, 17(4), 268-281.
- Menon, A. (1982). Wavelet-based signal denoising in natural gas pipelines. Solar Energy, 7(4), 639-646.
- Muller, R., Zhang, C., & Uddin, P. (1978). Packet routing protocols in urban traffic control systems. Electronics Letters, 37(3), 97-114.